Xiaomi Mijia M365 Custom Firmware Toolkit

• Base version of your firmware: 1.4.3 1.4.2 1.4.1 1.4.0 1.3.8 1.3.4 1.3.0
  1.3.8 is recommended over 1.4.0, it provides a much smoother riding experience.

• KERS min speed: Patch?
  Speed in km/h at which the scooter will start braking on it's own when the engine is not active.
  You will still have recuperative braking when using the brake lever.
  If you want "KERS OFF" then just put this to 40km/h.

• Maximum speed in Normal mode: Patch?
  The scooter will stay below this, add +1 to actually drive this fast.

• Maximum speed in ECO mode: Patch?
  The scooter will stay below this, add +1 to actually drive this fast.

• Motor start speed: Patch?
  Minimum speed in km/h before the engine will start.

• Motor power constant: Patch?
  Lower = More power. Too much power is not recommended for battery and motor life, stay above 32000.
  Original = 51575, DYoC = 40165, CFW2.0Weak = 27877, CFW2.0 = 25787

• Cruise control delay: Patch?
  How many seconds it takes for cruise control to kick in.

• Cruise control no beep:
  Disables beep sound when cruise control enables.

• Instant mode switch:
  Switch instantly between ECO and Normal mode while driving.

• Boot with ECO mode:
  The scooter will always start in ECO mode.

• Russian throttle algorithm (from CFW):
  Changes the throttle algorithm from speed-control to power-control.

• Battery voltage limit: Patch?
  If you want to connect a custom battery with a higher voltage.

• Remove hard speed limit of 35km/h:
  Removes code which checks that the speed is below 34.78km/h (12000/345).

• Remove charging mode:
  Fixes issue of scooter going into charge mode with an external battery connected in parallel.

• Change ESC<->BMS baud rate to 76800:
  Only if you use the compatible open source BMS!
  

• Wheel speed multiplier: Patch?
  For 10" wheels use 315, don't change otherwise.

Make sure to double check all of your entered values before submitting!
I AM RESPONSIBLE FOR THE ENTERED VALUES: Share